Wireless Setup - Belkin - G Plus MIMO F5D9231-4 v1 (Belkin Firmware)

Belkin - G Plus MIMO F5D9231-4 v1 (Belkin Firmware)


Wireless Setup Guide

Note: When setting up or changing your wireless settings it is a good idea to be plugged into the router with your network cable and not your wireless connection.
          If you are using your wireless connection and make any changes you will lose you wireless connection.

Step 1.

Open your favorite web browser and input your routers ip address in the address bar.
Please note that you must have the http:// in order to connect to your router/modem properly.

Need help finding you router IP address? Click here

Step 2.

Some router/modems require a username and/or password, if yours requires it, enter the routers username and password here.

If you don't know it you can check our list of default router and modem password list here.

If you have changed it and don't remember it you may have to reset your device to factory default using the reset button on most routers.

Step 3.

Once logged into your router click on "Channel and SSID".


Click To View Full Picture

Step 4.

For 'Wireless Channel' choose anything you like.

For 'Extension Channel' leave it at its default.

For 'SSID' set a name you would like to call your wireless.
What you put here is what will show up when you are searching for a wireless connection.

For 'Wireless Mode' choose '802.11g and 802.11b'

For 'Bandwidth' you can leave it at its default.

Check mark 'Broadcast SSID'

For 'Protected Mode' & '802.11e/WMM QoS' you may leave these on their defaults.

Click 'Apply Changes'


Click To View Full Picture

Step 5.

Once logged into your router click on "Security"


Click To View Full Picture

Step 6.

For 'Security Mode' choose 'WPA/WPA2-Personal (PSK)'

For 'Authentication' choose 'WPA-PSK+WPA2-PSK'

For 'Encryption Technique' choose 'TKIP+AES'

For 'Pre-shared Key (PSK)' put in a password of your liking, min 8 chars long.

Once all setting are set click 'Apply Changes'


Click To View Full Picture

All done!